Removing and installing rear wing door hinges — AUDI
Removing and installing rear wing door hinges on Audi: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy IV (SA, 2015–2020)
📋 Procedure
- Detach door arrester from detent mechanism.
- Unscrew upper bolts from openings in rear wing door .
- Unscrew bolts (5).
- Remove upper hinge (4) with seal (3).
- Detach door arrester from detent mechanism.
- Remove detent mechanism (2).
- Unscrew lower bolts from openings in rear wing door .
- Unscrew bolts (8).
- Remove lower hinge (7) with seal (6).
- Adjusting rear wing door (1).
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing crash sensor for pedestrian protection G570 / G571
- Removing and installing centre storage compartment – Audi
- Removing and installing toothed belt cover (bottom) – Audi A3
- Removing and installing NOx sender G295 – Audi A8 D4 3.0 TDI
- Checking fuel gauge senderG - four-wheel drive vehicles
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.