Removing and installing centre storage compartment: Audi A4 B8

🧭 Before you start

Fits: Audi A4 B8 (8K, 2007–2015)

Don't miss

• When installing, make sure all lugs have been fitted to seat bench frame and that centre storage compartment is fully engaged.
• Make sure there are no creases in the covers attached to the centre storage compartment.

📋 Procedure

1. Remove seat bench .
2. Disengage piping (2) at rear and on both sides from channel (arrow) of centre storage compartment (1).
3. Unclip centre storage compartment (2) at seat bench frame (1)(arrow).
4. Pull centre storage compartment forwards and disengage lugs at seat bench frame (1).
5. Detach centre storage compartment from seat bench frame.

6. When installing, make sure all lugs have been fitted to seat bench frame and that centre storage compartment is fully engaged.
7. Start at rear centre when engaging cover in channel of centre storage compartment.
8. When doing so, align cover piping with centre storage compartment and then clip cover into channel of centre storage compartment.
9. Proceed in a similar manner with the side cover.
10. Make sure there are no creases in the covers attached to the centre storage compartment.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing exhaust temperature sender 1 for cylinder bank 2G236
• Removing and installing moulded headliner and sun visors (Avant)
• Removing and installing subframe with attachments (four-wheel drive vehicles)
• Removing and installing inner constant velocity joint of drive shaft »VL100« · 1 torque figures
• Removing and installing steering column, right-hand drive from model year 2011