Removing and installing rear roof corner — AUDI
Removing and installing rear roof corner on Audi: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 2F
📋 Procedure
- Drill out rivets (2) and remove.
- Detach sealed and bonded joint (1) around circumference.
- Detach bonded joint between roof corner (3) and box body.
- Remove roof corner from box body.
- Remove sealing and adhesive compound residue.
- Lightly sand down bonding surfaces and clean.
- Lightly sand down bonding surfaces and clean.
- Apply sealing and adhesive compound.
- Fit roof corner and secure in position.
- Restore original joint.
- Seal all around with sealing and adhesive compound.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing subwoofer in rear shelf R157 – Audi · 1 torque figures
- Removing and installing cross member – Audi A6 C6 · 1 torque figures
- Connecting VAS 5051 and selecting functions
- Checking delivery pressure of power steering pump (vehicles with 10-cylinder TFSI engine)
- Removing and installing MMI display basic (up to week 35/08) · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.