Removing and installing rear right side panel trim — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T6 (7E)

• Renewed: as necessary

Don't miss

• Before installing, check retaining clips and clips (5) for damage and renew as necessary.After installing, check that the trim is located completely in the door seal bead and in the rear lid seal bead.

📋 Procedure

1. Unclip rear lock carrier cover (1) using removal wedge340970.
2. Unscrew bolts (arrows) for lower lock carrier cover (1) and remove lower lock carrier cover 70.
3. Switch off ignition.
4. Remove right C-pillar trim .
5. Remove upper D-pillar trim .

6. Unscrew two bolts (3) and remove fastening ring (4).
7. Pull out two pins (2).
8. Release side panel trim (1) from mounting brackets.
9. Depending on equipment level, detach wiring harnesses from side panel trim.
10. Remove side panel trim (1) from vehicle. [Note: Before installing, check retaining clips and clips (5) for damage and renew as necessary.After installing, check that the trim is located completely in the door seal bead and in the rear lid seal bead.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Locking injection pump at commencement of injection · 2 torque figures
• Audi 80 1987/90 1992 2.0 16V, 6A/ACE
• Detaching and attaching refrigerant lines at air conditioner compressor · 1 torque figures
• Changing and adjusting vacuum unit on turbocharger, only vehicles with engine codes BLS and BSU as of model year 2008
• Detaching and attaching air conditioner compressor at bracket (electrically driven) · 1 torque figures