Removing and installing rear propshaft, Crafter 4MOTION with Achleitner four-wheel drive — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

Don't miss

• To prevent noises due to imbalance, mark the position of the propshaft relative to the flanges.
• A nut remains fitted, to prevent front propshaft slipping off flange during further work.A second mechanic is required to proceed with further work.

📋 Procedure

1. Refer to general repair instructions . [Note: Remove and install propshaft with the help of a second mechanic.Before removing, mark positions of all parts relative to each other.Assemble in same position; otherwise an imbalance may be created which causes damage to bearings and rumbling noises.Keep propshaft straight; store and transport fully extended only.Depending on equipment, a flexible coupling may be installed on the propshaft, this remains on the shaft when it is removed.]
2. Remove bolts (arrows).
3. Remove underride guard (1) of rear centre propshaft bearing. [Note: To prevent noises due to imbalance, mark the position of the propshaft relative to the flanges.]
4. If no markings are found, mark position of propshaft relative to propshaft flange at both ends. [Note: A nut remains fitted, to prevent front propshaft slipping off flange during further work.A second mechanic is required to proceed with further work.]
5. Remove nuts (arrows) on transfer box for propshaft.

6. Unscrew propshaft bolts (arrows) on rear axle.
7. Unscrew bolts (arrows) of intermediate bearing (1).
8. Now unscrew remaining nut from front flange.
9. ⚠ To avoid damaging the protective boot in the centre bearing, remove, store and install the propshaft with the joint as straight as possible. — Remove propshaft to rear over flange and remove it complete in as straight as possible fashion with the aid of a second mechanic.
10. Install all parts which were marked in relation to each other in their original positions.
11. Align propshaft .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing glass panel – Audi Q7 · 3 torque figures
• Removing and installing toothed belt - engine code CZDB – Audi · 3 torque figures
• Installing gearbox - Audi Q5 with 2.0 ltr. TFSI engine and 4-cyl. TDI engine, PR-TH3/TM4 · 3 torque figures
• Removing and installing turbocharger control unit 1J724 · 4 torque figures
• Installing gearbox - Audi A4, A5, Q5 with 4-cyl. TDI engine (EA 288 - generation I), PR-TD1 · 3 torque figures