Removing and installing rear mid-range and bass loudspeaker — AUDI
Removing and installing rear mid-range and bass loudspeaker on Audi: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C6 (4F, 2004–2011)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Unscrew bolts (arrows |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off all electrical equipment.
- Remove ignition key.
- Remove rear door trim General body repairs, interior70.
- Unplug electrical connector (1) at rear left mid-range and bass loudspeaker R159(2).
- Unscrew bolts (arrows) (2 Nm). — 2 Nm (1.5 lb-ft)
- Detach rear left mid-range and bass loudspeaker R159(2) from mounting.
- Installation is performed in reverse sequence.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Dismantling and assembling drive shaft, triple roller joint AAR 3700i
- Removing and installing bevel box, vehicles with diesel engine
- Audi 1.8 gearbox removal & installation
- Detaching toothed belt from camshaft sprocket · 1 torque figures
- Removing and installing mechatronic unit for dual clutch gearbox J743
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.