Removing and installing mid-range loudspeaker, front left R103 — AUDI
Removing and installing mid-range loudspeaker, front left R103 on Audi: 6 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 Cabriolet B6/B7 (8H)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Unscrew bolts (arrows |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off all electrical equipment.
- Remove ignition key.
- Carefully pry speaker trim (1) off dash panel using removal leverV.A.G 80-200.
- Unscrew bolts (arrows) (2 Nm) at mid-range loudspeaker, front left R103(1). — 2 Nm (1.5 lb-ft)
- Pivot mid-range loudspeaker, front left R103(1) outwards and unplug connector at mid-range loudspeaker, front left R103(1).
- Installation is performed in reverse sequence.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing headlight range control motor V48/V49 - halogen headlights
- Removing and installing headlight range control motor V48/V49 - LED headlights up to model year 2014
- Removing and installing fog light bulb L22/L23 – Audi A8 D4
- Removing and installing tail light cluster on rear lid - Avant
- Removing and installing switches in dash panel – Audi TT Mk1
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.