Removing and installing rear member — AUDI

🧭 Before you start

Fits: platform code 42

• Special tools named: V.A.G 1438, T10039/1

Don't miss

• If rear member cannot be removed, vehicle frame may be flexed slightly (max. 1 mm) using mechanical door tensioner V.A.G 1438 and release lever T10039/1.

📋 Procedure

1. Remove service flap .
2. Vehicles with dual clutch gearbox: Remove air cleaner housing 24Air cleaner; Removing and installing air cleaner housing.
3. Remove rear lid lock .
4. Remove bumper cover (centre section) .
5. Remove bolts (arrows) for heat shield.

6. Move clear electrical wiring harness and rear lid lock cable at rear member.
7. Loosen bolt (1) and remove bolt (3).
8. Turn adjusting buffer (2) to one side (arrow).
9. Unscrew bolts (arrows) (left and right).
10. Detach rear member. [Note: If rear member cannot be removed, vehicle frame may be flexed slightly (max. 1 mm) using mechanical door tensioner V.A.G 1438 and release lever T10039/1.]
11. Install rear lid lock .
12. Install service flap .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing sump (top section) - all engine codes except CJZA, CYVB
• Removing and installing subframe without steering rack (vehicles without high-voltage system)
• Renewing bonded rubber bush for wheel bearing housing – Audi
• Removing and installing trailing arm with mounting bracket
• Removing and installing silencer – Audi 4.2