Removing and installing rear left chest vent control motor V315 — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

Don't miss

• Mark electrical connector and control motor.
• If the actuator socket and shaft are not opposite one another, the socket in the control motor must be turned. Observe general notes .
• Position control motor on air distribution housing. The actuating arm must engage (arrow) in actuator socket (4).

📋 Procedure

1. Observe general notes .
2. Remove rear vent General body repairs, interior68Centre console; Removing and installing centre console.
3. Remove air duct for rear vent .
4. Mark electrical connector and control motor.
5. Unplug electrical connector (3).

6. Remove bolts (1 and 4).
7. Detach the control motor (2) from the flap shaft (5).
8. ⚠ Risk of damage to control motor.The actuator socket in the control motor must not be turned by hand when the connector is not plugged in, as this could damage the electronics in the control motor.If it is necessary to turn the actuator socket in the control motor, turn it carefully and slowly by hand with the connector plugged in. — The actuator socket in the control motor (3) can only be attached to the shaft (5) in one position. [Note: If the actuator socket and shaft are not opposite one another, the socket in the control motor must be turned. Observe general notes .]
9. Plug in electrical connector (1).
10. Position control motor on air distribution housing. The actuating arm must engage (arrow) in actuator socket (4).
11. Tighten the bolts to torque .
12. Route the wiring harness (2) such that it cannot come into contact with moving components (e.g. control motor lever).
13. Read out event memory and delete any entries displayed.
14. Perform basic setting.
15. Perform final control diagnosis.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing aerial amplifier – Audi A2 · 1 torque figures
• Removing and installing multi-function steering wheel control unit J453 · 1 torque figures
• 6-speed manual gearbox 0A3, four-wheel drive — Removing reversing light switch F4 · 1 torque figures
• Removing and installing rear side airbag (fixed backrest)
• Removing and installing switch for four-way lumbar support · 1 torque figures