Removing and installing multi-function steering wheel control unit J453 — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove driver's storage compartment General body repairs, interior70.
4. Screw out the two bolts (arrows) (3 Nm) and detach control unit (1). — 3 Nm (2.2 lb-ft)
5. Install accordingly in reverse order of removal.
6. Control unit encoding and adaption Radio, telephone and navigation system, self-diagnosis01.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Vehicle level senders at rear axle
• Layout of rear axle components (four-wheel drive vehicles)
• Removing and installing vane pump (vehicles with 6-cyl. 2-valve petrol engine)
• Removing and installing vane pump (vehicles with 6-cyl. 5-valve petrol engine except bi-turbo)
• Checking ageing of lambda probes -G39 and -G108 upstream of catalytic converter