Removing and installing rear floor covering, single cab — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

Don't miss

• Remove tool box and warning triangle.
• When installing rear floor covering (1), make sure it overlaps front floor covering (3) in area (2) correctly.The right-hand side is mirror-inverted.

📋 Procedure

1. Switch off ignition.
2. Remove tool box and warning triangle.
3. Remove centre console .
4. Remove back panel trim .
5. Remove front left and right sill panel mouldings .

6. Remove front seats .
7. Unclip press studs (2).
8. Lift rear floor covering (1), and remove it from vehicle through door opening.
9. Guide unfolded rear floor covering (1) through door opening, position and install.
10. Clip in press studs (2). [Note: When installing rear floor covering (1), make sure it overlaps front floor covering (3) in area (2) correctly.The right-hand side is mirror-inverted.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing tail light · 2 torque figures
• Removing and installing trailer socket U10 · 2 torque figures
• Removing and installing upper part of sump · 1 torque figures
• Removing and installing brake caliper, brake caliper FN 44
• Removing and installing steering column switch module (SCSM) · 2 torque figures