Removing and installing rear Climatronic operating unit E265 — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

📋 Procedure

1. If the rear Climatronic operating unit E265 is renewed, select "“Control unit replacement”" in "“Guided Fault Finding”" mode.
2. Remove centre console trim (rear) General body repairs, interior68Centre console; Exploded view - centre console.
3. Release the retainer tabs (arrows) on the left and right.
4. Press the operating unit (2) out of the rear cover (1).
5. When renewing a rear Climatronic operating unit E265, take care to select the correct version Electronic parts catalogue.

6. Perform/check coding.
7. Perform basic setting.
8. Read out event memory (and eliminate the cause of any entries displayed).
9. Check adaption.
10. Perform final control diagnosis if applicable.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing central tube retainer (Roadster) · 1 torque figures
• Removing height adjustment unit – Audi TT Mk1
• Removing Bowden cable – Audi TT Mk1
• Adjusting selector finger and selector sleeve – Audi A2
• Removing and installing third rear three-point seat belt (folding backrest, rear)