Removing height adjustment unit: Audi TT Mk1

🧭 Before you start

Fits: Audi TT Mk1 (8N)

Don't miss

• Actuate height adjustment handle. Gas-filled strut must be released after approx. half distance. Re-set adjuster (2) if necessary.

📋 Procedure

1. Remove seat .
2. Remove height adjustment handle .
3. Remove seat side trim .
4. Remove seat cushion .
5. Disengage nipple (3) at lever.

6. Disengage Bowden cable (5) at adjuster (2).
7. Press out pins (4) (3x) from outside.
8. Take out height adjustment unit (1).
9. Engage nipple (3) at lever.
10. Lay cable around idler wheel.
11. Engage Bowden cable (5) at adjuster (2).
12. Turn adjuster (2) until cable makes contact with idler wheel.
13. Attach height adjustment handle.
14. Actuate height adjustment handle. Gas-filled strut must be released after approx. half distance. Re-set adjuster (2) if necessary.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing bumper cover - Audi A3 with auxiliary side radiator
• Removing and installing magnetic coils for fuel tank shut-off valves N361/N362
• Removing and installing filler connection for natural gas tank
• Renewing needle bearings (polygon bearings) for stub shaft (right-side)
• Removing and installing gear sensor G676 and gear sensor 2G869