Removing and installing rear Climatronic operating and display unit E265 — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

• Special tools named: VAS 5051

Don't miss

• The rear Climatronic operating and display unit E265(B) is held in position in the centre console by way of the clips (C) (on the upper and lower side).

📋 Procedure

1. Switch off ignition.
2. Remove the rear centre console vent .
3. Reach into the opening (A) and slide the rear Climatronic operating and display unit E265(B) out of the centre console. [Note: The rear Climatronic operating and display unit E265(B) is held in position in the centre console by way of the clips (C) (on the upper and lower side).]
4. Release the fasteners of the connectors (E) to (G) by pressing the retainer tabs (D) and unplug the connectors.
5. On vehicles with heated rear seats, release and unplug the connector for actuating the seat heating.

6. Check the clips (C) at the rear Climatronic operating and display unit E265 .
7. Re-install components in reverse order of removal.
8. Interrogate the fault memory of the front operating and display unit, Climatronic control unit J255 and the rear Climatronic operating and display unit E265 and erase any faults displayed "Guided Fault Finding" function of vehicle diagnostic, testing and information system VAS 5051.
9. Check the adaption of the rear Climatronic operating and display unit E265"Guided Fault Finding" function of vehicle diagnostic, testing and information system VAS 5051.
10. Perform air conditioner basic setting (and if applicable final control diagnosis) "Guided Fault Finding" function of vehicle diagnostic, testing and information system VAS 5051.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing headlight housing - vehicles with LED headlights from model year 2015 onwards
• Removing and installing headlight range control motor V48/V49 - vehicles from model year 2015 onwards
• Draining and filling gear oil - transfer box (gearbox with separate oil systems)
• Removing and installing charge air cooler - vehicles without hybrid drive
• Filling and bleeding fuel system - vehicles without hybrid drive