Removing and installing headlight range control motor V48/V49 - vehicles from model year 2015 onwards — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018)

📋 Procedure

1. Remove wheel.
2. Remove front wheel housing liner General body repairs, exterior66Wheel housing liners; Removing and installing wheel housing liner (front).
3. Remove bolts (arrows).
4. Detach housing cover (1) from headlight housing.
5. If fitted, release fastener (2) and unplug electrical connector (3).

6. Remove bolts (1, 5).
7. Slide ball head of actuator shaft out of its mounting (3) by swivelling control motor (1) inwards (arrow).
8. Remove control motor from headlight housing.
9. Unplug electrical connector (4).
10. Insert ball head of actuator shaft in mounting on reflector from the side; to do so, pull reflector to rear.
11. Close housing cover and tighten bolts.
12. Adjust headlights .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing mounting profile · 1 torque figures
• Removing and installing waste water tank
• Removing and installing alternator, vehicles with 5-cylinder diesel engine · 1 torque figures
• Removing and installing radio system "“RSD 2000”" · 1 torque figures
• Removing and installing radio system "“RSD 4000”" and radio navigation system "“RNS 6000”" · 1 torque figures