Removing and installing radio system "“RSD 2000”" — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

• Special tools named: locking bar

Don't miss

• Depending on the equipment level, 2 connectors may be present.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Using removal wedge3409, carefully lever off centre console cover in area indicated by (arrow).
3. Completely unclip cover (1).
4. Release and disconnect connector (arrow). [Note: Depending on the equipment level, 2 connectors may be present.]
5. Unscrew the 4 securing bolts (arrows) from radio system.

6. Pull radio system out of installation slot until connectors at rear are accessible.
7. Press together locking mechanism of locking bar in (direction of arrow).
8. Swing locking bar in (direction of arrow). This causes the connector to be pushed out.
9. Release aerial connection (arrows) and pull it off.
10. Connect and engage connectors on radio system.
11. ⚠ Risk of damage to display and operating keys!When inserting the radio system into the installation slot by pressing against the display or operating keys, the unit could become damaged.When inserting the radio system never press against the display or operating keys. — Push radio system in a straight line into installation slot in dash panel.
12. Screw in 4 securing bolts (arrows), and tighten them to 2 Nm. — 2 Nm (1.5 lb-ft)
13. Install centre console cover.
14. Check coding of radio system and re-code if necessary .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing air filter element (right side) (cylinder bank 1)
• Removing and installing oil pump - from engine number BSM 006 226 onwards
• Removing and installing auxiliary radiator (left-side) – Audi
• Removing and installing exhaust pipes (left-side) – Audi BSM
• Intake manifold (bottom section) with fuel rail - exploded view · 1 torque figures