Removing and installing rear bumper - overview: Audi TT Mk1

🧭 Before you start

Fits: Audi TT Mk1 (8N)

Don't miss

• First secure guide with nuts to ensure that bumper cover can engage properly when it is installed.
• The bumper cover (1) can remain installed when removing trim cover (bottom)(2).

📋 Procedure

1. Remove rear wheels.
2. Remove wheel housing liners (rear) .
3. Open rear lid.
4. Unclip trim covers (left and right ).
5. Unscrew Torx bolts and .

6. Loosen hexagon nuts in wheel housings.
7. Also loosen bolts on side for securing guides and press guides on both sides down slightly.
8. ⚠ If guide is not loosened, the cover cannot be taken out of the catches. This could cause the paintwork to become damaged. — Detach cover from guides, pulling it to the side.
9. Detach cover from vehicle towards rear.
10. To remove, unscrew nuts and securing bolts on side and detach guide to the side.
11. First secure guide with nuts to ensure that bumper cover can engage properly when it is installed.
12. Then secure guide with bolts on side. [Note: The bumper cover (1) can remain installed when removing trim cover (bottom)(2).]
13. Prise out clips (3).
14. Remove bolts (4) and take off trim cover (bottom) (2).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing front three-point seat belt with belt height adjuster
• Clutch pedal switch -F36
• Testing fuel pump relay -J17 and relay activation – Audi 2.8
• Renewing seal for propshaft flange
• Checking CO2 level in additional heater exhaust gas (heater with no recirculating pump -V55)