Removing and installing rear bonded rubber bushes for rear final drive — AUDI

🧭 Before you start

Fits: Audi Q7 (4M, 2015–)

📋 Procedure

1. Depending on equipment version: Remove rear axle steering rack .
2. Remove rear final drive Final drive39Final drive; Removing and installing final drive.
3. Remove nuts (arrows) and detach cover (1) of air supply unit.
4. Unclip air filter (1) from bracket and push to one side with hoses (arrows) attached.
5. Set up assembly tool T40032 and assembly tool T40033 at bonded rubber bush and subframe, as shown in illustration.

6. Pull bonded rubber bush out of subframe.
7. Set up assembly tool T40032 and assembly tool T40033 at bonded rubber bush and subframe, as shown in illustration.
8. Pull bonded rubber bush into subframe as far as stop.
9. Install rear axle steering rack .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing lower transverse link, four-wheel drive vehicles
• Removing and installing water drain hose (rear) – Audi Q7
• Removing and installing belt end fitting (front) - NAR version
• Removing and installing rear parking aid senders – Audi Q5
• Renewing oil seal for stub shaft on bevel box (right-side)