Removing and installing rear belt height adjuster (2nd row) — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

📋 Procedure

1. Detach C-pillar trim from body .
2. Move C-pillar trim to side with belt webbing attached.
3. Remove bolt (3).
4. Detach guide fitting (2) with belt (1).
5. Remove bolt (5).

6. Lift belt height adjuster (4) off C-pillar. [Note: When supplied as replacement parts, belt height adjusters are always set to bottom detent position (assembly position).If belt height adjusters are removed and re-fitted, they must be set to bottom detent position (assembly position).]
7. Engage belt height adjuster (4) in C-pillar.
8. Screw in bolt (5) and tighten to specified torque.
9. Install guide fitting (2) and tighten bolt (3) to specified torque.
10. Attach C-pillar trim to body .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Detaching timing chains from camshafts, removing and installing chain tensioners · 3 torque figures
• Removing and installing turbocharger 1 control unit J724 · 4 torque figures
• Removing and installing drive shafts · 5 torque figures
• Exhaust manifold - exploded view · 7 torque figures
• Removing and installing glass panel – Audi Q7 · 3 torque figures