Removing and installing radio system "“RCD 500”" — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

• Special tools named: locking bar

Don't miss

• Danger of damage to component surfaces.When using leverage tools, mask the component in the area of view with commercially available adhesive tape. — Using removal wedge3409, carefully lever out centre console cover (arrows).

📋 Procedure

1. Remove any CDs left in the unit Operating manual.
2. Switch off ignition and all electrical loads, and pull out ignition key.
3. ⚠ Danger of damage to component surfaces.When using leverage tools, mask the component in the area of view with commercially available adhesive tape. — Using removal wedge3409, carefully lever out centre console cover (arrows).
4. Unscrew securing bolts (arrows) from radio system.
5. Pull radio system out of installation slot until connectors at rear are accessible.

6. Press locking mechanism of connector together in (direction of arrow).
7. Swing locking bar upwards in (direction of arrow) and disconnect connector.
8. Release and disconnect connectors from aerial connections (arrows).
9. Connect and engage connectors on radio system.
10. ⚠ Risk of damage to display and operating keys!When inserting the radio system into the installation slot by pressing against the display or operating keys, the unit could become damaged.When inserting the radio system never press against the display or operating keys. — Push radio system straight into dash panel.
11. Screw in and tighten the 4 securing bolts (arrows).
12. Install centre console cover.
13. If necessary, deactivate transport protection device of CD changer in RCD 500 .
14. Check coding of radio system and re-code if necessary .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing front passenger seat adjustment switch E157
• Removing and installing glove box - vehicles with knee bolster / knee airbag (country-specific version)
• Removing warning lamp for airbag deactivated on front passenger side · 1 torque figures
• Removing and installing knee airbag (front passenger side)
• Removing and installing impact absorber for rollover bar · 1 torque figures