Removing and installing propshaft flange — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

• Special tools named: puller

📋 Procedure

1. Remove propshaft Transfer box and final drive39Propshaft; Removing and installing propshaft.
2. Screw counter-hold tool3145 onto propshaft flange.
3. Remove bolt for propshaft flange.
4. Screw bolt M12 x 1.5 mm (120 mm in length) into output shaft.
5. Fit Kukko 18-1 puller with thrust pieceVW 431.

6. Pull propshaft flange off output shaft.
7. Use a thread chaser, for example, to clear residual locking fluid from the threaded hole in output shaft.
8. Apply locking fluid to thread of bolt for propshaft flange Electronic Parts Catalogue.
9. Apply a bead of sealant under bolt head and under washer (gearbox side) Electronic Parts Catalogue.
10. Insert bolt for propshaft flange with washer and tighten it.
11. Install propshaft Transfer box and final drives39Propshaft; Removing and installing propshaft.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking air conditioner components on vehicles with high-voltage system
• Removing and installing control motor for left footwell temperature flap V411
• Operation of heater coolant shut-off valve
• Removing and installing high-voltage wiring harness for hybrid battery PX1
• Checking fuel system pressurisation pump G6 (6.0 bar high-pressure pump)