Removing and installing poly V-belt, vehicles with air conditioning system — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

• Timing position: the crankshaft or camshaft is set and locked during this job

Don't miss

• Mark direction of rotation of poly V-belt.

🔧 Engine codes this applies to

📋 Procedure

1. If fitted, remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
2. Mark direction of rotation of poly V-belt.
3. Using ring spanner (3) turn tensioning device (1) on bolt (2) clockwise in (direction of arrow) to slacken the poly-V belt.
4. Lock tensioning device (1) in place using locking pin T10060 A.
5. Release tension from tensioner (1).

6. Remove poly V-belt.
7. Fit poly V-belt as shown in illustration.
8. Using ring spanner (3) turn tensioning device (1) on bolt (2) clockwise in (direction of arrow) until a limit stop can be felt.
9. Pull out locking pin T10060 A.
10. Release tension from tensioner (1).
11. Check that poly V-belt is properly seated.
12. Start engine and check that belt runs properly.

Other AUDI procedures

• Removing and installing gearbox mounting – Audi TT Mk1 1.2
• Emptying fuel tank, front-wheel drive, engine codes CAYD, CAYE, CFHC, CFHE, CFHF, CLCA, CLCB, CFJA
• Checking delivery pressure of fuel system pressurisation pump G6 - vehicles with 6.0 bar low pressure fuel system
• Checking fuel pressure of fuel pump, vehicles with 6.0 bar low pressure fuel system
• Removing and installing engine bracket
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures