Removing and installing passenger side footwell vent: Audi A8 D4
Step-by-step removing and installing passenger side footwell vent for the Audi A8 D4: 7 steps, 2 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A8 D4 (4H, 2010–2017)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1 Nm (0.7 lb-ft) | Screw out the bolt (A |
| 1 Nm (0.7 lb-ft) | Unscrew bolt (A |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Move the front right seat (front passenger's seat) as far back as it will go.
- Switch off ignition.
- Remove the glove compartment General body repairs, interior68Shelves/storage compartments/covers; Removing and installing glove compartment.
- Unplug the connector (A) from the right footwell vent temperature sender G262(B).
- Remove bolts (D).
- Remove the right footwell vent (E).
- Interrogate the event recorder of the front air conditioner operating and display unit, Climatronic control unit J255 and erase any faults displayed in "“Guided Fault Finding”" mode.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.