Removing and installing parking lock solenoid N486/parking lock sender G747 — AUDI

🧭 Before you start

Fits: Audi A4 B9 (8W, 2015–)

📋 Procedure

1. Remove rear noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
2. Remove mechatronic unit Removing and installing mechatronic unit.
3. Remove bolts (arrows) and press coolant pipe for gearbox to one side.
4. Unscrew bolts (arrows) and move parking lock manual release cable (1) to one side.
5. Remove bolt (2).

6. Unplug electrical connector (3).
7. Remove bolts (arrows) and detach cover (1) for parking lock.
8. Press seal for parking lock shaft out of cover.
9. Remove bolts (arrows) and detach parking lock solenoid N486(item 1).
10. Install seal for parking lock shaft .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view of "„K2/K3“" clutch housing
• Checking thermostat for map-controlled engine cooling system
• Checking fuel pump (electrical test) - TFSI and 6-cylinder engines
• Adapting kick-down function - vehicles with automatic gearbox or dual clutch gearbox
• Adjusting handbrake – Audi A4 Cabriolet B6/B7 / A4 B6/B7