Removing and installing parking brake switch: Audi TT Mk2
Step-by-step removing and installing parking brake switch for the Audi TT Mk2: 8 steps, 1 torque figure.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk2 (8J, 2006–2014)
Don't miss
- Note different versions of handbrake trim.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 8 Nm (5.9 lb-ft) | Item 1- bolt (2x), tightening torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove centre console trim General body repairs, interior68Centre console; Exploded view - centre console.
- Detach locking knob (1). [Note: Note different versions of handbrake trim.]
- One-piece trim for handbrake (2): release and pull off to front.
- Two-piece trim for handbrake: release handle and pull off to front.
- Remove two-piece trim for handbrake lever.
- Unclip handbrake switch (4).
- Unplug connector.
- Installation is carried out in the reverse sequence.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Audi 3.2 FSi 3.1 AUK/BKH timing chain replacement
- Audi 2.0 16V TDI Injector R&I
- Audi 1.4 TDI Injector R&I
- A4_8K/A5_8T 2.0 TDI CR_GenII Timing belt
- A4_8K/A5_8T_2.0 TFSi_Generation II Timing Chain
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.