Removing and installing panel with cigarette lighter and cover — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• Make sure connector (4) is plugged in opposite direction of travel.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove function selection switch 2E272(item 6)91.
4. Remove centre console .
5. Unplug electrical connector at cigarette lighter.

6. Turn centre console upside down.
7. Release connector (4) from U-clip.
8. Unscrew bolts (5).
9. Take panel with cigarette lighter and cover (3) out of centre console (1).
10. Make sure connector (4) is plugged in opposite direction of travel.
11. Secure connector (4) in position in centre console with U-clip (2).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view - intake manifold (bottom section) with fuel rail · 5 torque figures
• Removing gearbox - Audi Q5 with 2.0 ltr. TFSI engine
• Removing and installing air conditioner compressor - vehicles with 8-cyl. FSI engine
• Removing and installing rear final drive, Audi A3, TT (not RS 3, TT RS, A3 USA)
• Adjusting input gear · 3 torque figures