Removing and installing over-centre spring with mounting bracket removed — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T6 (7E), VW Transporter T6 (7F)

📋 Procedure

1. Carefully clamp lower section of mounting bracket/clutch pedal in vice with protective jaw pads.
2. Depress clutch pedal down to stop.
3. Compress over-centre spring (B) using pliers (A).
4. First remove over-centre spring from bar (C) of mounting bracket.
5. Then guide away from clutch pedal pin.

6. Carefully release tension from over-centre spring.
7. Carefully clamp lower section of mounting bracket/clutch pedal in vice with protective jaw pads.
8. Depress clutch pedal down to stop.
9. Compress removed over-centre spring (B) using pliers (A).
10. First fit over-centre spring on pin of clutch pedal.
11. Then lock over-centre spring into mounting bracket extension (C).
12. Carefully release tension from over-centre spring.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing retaining plate (left-side) with control motors V108 and V110
• Removing and installing retaining plate (right-side) with control motors V109 and V111
• Removing and installing heater housing, right-side (with retaining plate, right-side, for control motors detached)
• Removing and installing battery cooling module – Audi A8 D4
• Removing and installing brake pads (1LA / 1LB / 1LJ / 1LD / 1ZT + S4 / S5)