Removing and installing operating cable for seat longitudinal adjustment — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

📋 Procedure

1. Remove seat .
2. Attach seat repair standVAS 6136 to engine and gearbox supportVAS 6095.
3. Attach front seat to seat repair standVAS 6136.
4. Remove side trim (sill side) .
5. Remove handle for seat longitudinal adjustment

6. Press cable sleeve out of cable support bracket in direction of (arrow A).
7. Detach operating cable (1) for seat longitudinal adjustment from release lever (arrow B).
8. Drill out pop rivets (arrows) using a ∅ 4.0 mm bit and detach retaining plate (1) for relay socket and wiring harness.
9. Release securing clip (4) at operating cable in direction of (arrow A) and lift off securing clip (arrow B).
10. Release retaining spring (2) using a narrow-bladed screwdriver (3).
11. Pull seat rail release lever (1) upwards out of rotary shaft.
12. Detach operating cable for seat longitudinal adjustment.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing steering wheel – Audi A1 · 1 torque figures
• Removing and installing sealing flange (front), engine code BVY, BVZ
• Removing and installing cylinder head cover - vehicles with engine codes AZV, BKD
• Removing and installing exhaust gas recirculation valve N18 with exhaust gas recirculation potentiometer G212
• Removing and installing door trim (rear) – Audi A8 D4