Removing and installing oil pump, vehicles without balance shaft module — AUDI
Removing and installing oil pump, vehicles without balance shaft module on Audi: 10 steps, engines CAAA, CAAB, CAAC, CAAD.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Transporter T6 (7F), VW Transporter T6 (7E)
- Renewed: o-ring between oil pump
Don't miss
- Renew O-ring between oil pump and oil intake pipe.
- If oil pump does not move easily, it must be renewed.A damaged toothed belt must be renewed.The toothed belt can sag after long use, this is not a fault.
📋 Procedure
- Remove sump .
- When oil pump is to be renewed, unscrew bolts (4) and remove oil intake pipe (3).
- Unscrew bolts (arrows) and remove baffle (2).
- Detach oil pump (1) from toothed belt and remove pump. [Note: Renew O-ring between oil pump and oil intake pipe.]
- Insert new dowel sleeves when oil pump has no dowel sleeves (arrows) for centring oil pump.
- Check oil pump for ease of movement, turn toothed belt pulley with one finger for this. [Note: If oil pump does not move easily, it must be renewed.A damaged toothed belt must be renewed.The toothed belt can sag after long use, this is not a fault.]
- Check toothed belt for oil pump.
- Fit oil pump with toothed belt pulley into toothed belt and tighten along with baffle.
- Install sump .
- Replenish engine oil and check oil level .
Other AUDI procedures
- Removing and installing oil filter housing with engine oil cooler "“single turbo engine”"
- Removing and installing fuel tank, engine codes AXB, AXC, BRR, BRS, AXD, AXE, BLJ, BNZ, BPC
- Assembly overview - cylinder block, gearbox end · 1 torque figures
- Removing and installing particulate filter - vehicles with front-wheel drive
- Checking fuel delivery rate of fuel system pressurisation pump G6 - vehicles with supplementary fuel pump V393
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.