Removing and installing movable section of sliding window, California — AUDI

🧭 Before you start

Fits: platform codes SF, SG

Don't miss

• Make sure that button (2) for sliding window (1) does not engage in this position; it must remain in open position.
• Ensure that the centring pins (2) and (3) swing outwards.Hold button in open position to ensure locking peg remains down.

📋 Procedure

1. Cover glass surfaces on cross section.
2. Push driver's seat forwards as far as it will go.
3. Remove roller blind of left side window.
4. Push away roof side member trim.
5. Move sliding window (1) to middle position.

6. Make sure that button (2) for sliding window (1) does not engage in this position; it must remain in open position.
7. Carefully push upper plastic frame upwards using removal wedge3409.
8. Prise upper pin (2) of sliding window (1) out of guide.
9. Carefully push upper plastic frame upwards using removal wedge3409.
10. Prise upper pin (2) on left of sliding window (1) out of guide.
11. Fold down upper part of sliding window (1) and pull out of guide. [Note: Ensure that the centring pins (2) and (3) swing outwards.Hold button in open position to ensure locking peg remains down.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing mounting bracket for bonnet Bowden cables
• Removing and installing backrest release mechanism (seats with manual or electric adjustment)
• Removing and installing pulley, "“Denso”" air conditioner compressor, version "“2”" · 1 torque figures
• Removing and installing rear coolant pipe – Audi A8 D2
• Removing and installing fuel gauge sender 3G237 (tubular sender, left-side)