Removing and installing mounting with drive unit for rear spoiler — AUDI

🧭 Before you start

Fits: platform code 42

📋 Procedure

1. Extend spoiler Owner's Manual.
2. Remove bumper cover mounting (centre) .
3. Remove bolts (arrows).
4. Detach cover (left-side) (1) for tail light.
5. Lift out mounting (2) with drive unit for rear spoiler and guide out electrical connector (4). [Note: Ignore (item 3).]

6. Insert mounting (B) with drive unit for rear spoiler in rear member, secure in position with bolt (1) and align mounting Gap widths at rear spoiler.
7. Use bolt (2) to secure mounting with drive unit for rear spoiler in position in elongated hole.
8. Tighten bolt (3) to specified torque.
9. Position tail light covers (left (A) and right (C)).
10. Tighten bolts (1, 2, 4) to specified torque.
11. Install bumper cover mounting (centre) .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing magnesium intake manifold – Audi CAUA
• Removing and installing front wheel speed sensor – Audi · 2 torque figures
• Removing gearbox - vehicles with 2.4 ltr. MPI or 2.8 ltr./3.2 ltr. FSI engine · 1 torque figures
• Removing and installing rear shelf with sun blind (rear)
• Removing and installing seat adjustment switch – Audi A6 C6 · 3 torque figures