Removing and installing motor for front Bitron blower regulation V305 — AUDI
Removing and installing motor for front Bitron blower regulation V305 on Audi: 5 steps, 1 torque figure.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1 Nm (0.7 lb-ft) | Remove bolts (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Disconnect connection from Motor for front Bitron blower regulation V305.
- Remove bolts (1) (1 Nm). — 1 Nm (0.7 lb-ft)
- Unscrew bolts (arrows).
- Pull dash panel (1) in direction of (arrow) into vehicle interior.
- Remove motor for front Bitron blower regulation V305 from front heater and air conditioning unit.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing coolant pipe (top right) – Audi A8 D3
- Removing and installing charge air cooler (right-side) – Audi
- Checking fuel pressure regulator and residual pressure (engine code letters BHT)
- Renewing sealing flange (pulley end) with crankshaft oil seal
- Removing and installing high-pressure pump - vehicles up to 09.2005
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.