Removing and installing manual release cable for tank flap — AUDI

🧭 Before you start

Fits: Audi A3 (8V, 2012–2020)

📋 Procedure

1. Remove tank filler flap locking motor .
2. Thread manual release cable (1) out of guide (4).
3. Disengage lug (2) at mounting (3) for manual release mechanism and pull it out of cable support bracket.
4. Remove tank flap unit .
5. Remove side trim General body repairs, interior70Passenger compartment trim panels; Removing and installing side trim.

6. Remove loudspeaker Communication91Sound system; Overview of fitting locations - sound system.
7. Move manual release cable (3) clear at mounting (4).
8. Move aerial connector (5) clear at inner cover (1).
9. Prise off inner cover using removal wedge3409 and move clear grommet (2) with manual release cable.
10. Take out manual release cable.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing engine oil cooler on lock carrier
• Removing and installing side airbag (front) with airbag igniter
• Removing and installing sill panel trim (rear) – Audi Q5
• Removing and installing rear lid trim (bottom) - Saloon – Audi
• Removing and installing front seat backrest - multi-contour seat