Removing and installing main fuse box (right A-pillar) — AUDI

🧭 Before you start

Fits: platform code 42

Don't miss

• Mark assignment of wires (2, 3, 4) and remove nuts.
• Exact assignment for main fuse box (right A-pillar) can be found in applicable current flow diagram .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove right A-pillar trim 70.
3. Fold back floor covering in area of A-pillar.
4. Turn fasteners (1) and (3) 90° anti-clockwise and open main fuse box cover (2).
5. Unscrew nut (5) for "“engine compartment”" battery cable.

6. Remove battery isolation igniter N253(item 6)69.
7. Unscrew nut (7) for "“vehicle interior”" battery cable.
8. Mark assignment of wires (2, 3, 4) and remove nuts.
9. Take out wires.
10. Unscrew nuts (arrows).
11. Detach main fuse box (1) (right A-pillar) from A-pillar. [Note: Exact assignment for main fuse box (right A-pillar) can be found in applicable current flow diagram .]
12. Install battery isolation igniter N25369.
13. Install right A-pillar trim 70.
14. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing coolant union – Audi 2.5 TDI
• Removing and installing wiring harness for unit injectors
• Audi RS5 ancil belt removal
• Removing, installing, dismantling and assembling drive pinion
• Checking axial clearance of Torsen differential and adjusting