Removing and installing main fuse box, on rear right in luggage compartment - vehicles with 2.5 ltr. TFSI engine and 3.2 ltr. MPI engine — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• Exact contact assignment of relay and fuse holder can be found in appropriate current flow diagram .

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Switch off ignition and take out ignition key.
3. Take out rear moulded insert (3) for tools from under luggage compartment floor.
4. Take out front moulded insert (left-side) (1).
5. Release securing strap (3) and take out front moulded insert (2) for tools (right-side).

6. Open cover on main fuse box, located in luggage compartment.
7. Unscrew electrical wiring (1), (2) and (4).
8. Unplug electrical connector (5) for battery isolation igniter N253.
9. Unscrew nuts (arrows).
10. Take out main fuse box, in luggage compartment (3). [Note: Exact contact assignment of relay and fuse holder can be found in appropriate current flow diagram .]
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking data exchange between control units
• Connecting vehicle diagnostic, measuring and information system VAS 5051 or fault reader V.A.G 1551 and selecting function
• Checking air quality sensor -G238
• Testing Hall sender
• Testing secondary air pump relay -J299 and activation