Removing and installing loudspeaker in back panel side trim - Roadster — AUDI

🧭 Before you start

Fits: Audi TT Mk1 (8N)

Don't miss

• Loudspeaker (1) must be installed such that connector (5) is positioned as shown.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical consumers.
2. Remove ignition key.
3. Remove back panel side trim General Body Repairs, Interior70.
4. Screw out bolts (2) (2.5 Nm) at loudspeaker (1). — 2.5 Nm (1.8 lb-ft)
5. Unplug connector (5) and detach loudspeaker (1) from bracket (3).
6. Bracket (3) is attached to back panel by means of three bolts (4) (2 Nm). — 2 Nm (1.5 lb-ft)
7. Loudspeaker (1) must be installed such that connector (5) is positioned as shown.
8. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing brake master cylinder, Audi A1
• Removing and installing steering rack - vehicles up to and including model year 2014
• Checking fresh air and air recirculation flap control motor V154 - heater, manually controlled air conditioner
• Checking air recirculation flap control motor V113 - automatically controlled air conditioner
• Removing and installing bracket for arrester – Audi A1 · 1 torque figures