Removing and installing ISOFIX retainer: Audi A3

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• Make sure the cover does not tear at the opening for the ISOFIX bracket. — Pull cover (1) to front off ISOFIX brackets (2).
• For greater clarity, padding is shown without cover in illustration.
• Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.
• If airbag warning lamp K75 indicates a fault following installation, you must interrogate, erase and then re-interrogate the fault memory .

📋 Procedure

1. ⚠ Observe safety regulations for pyrotechnic components .Before handling pyrotechnic components (e.g. unplugging the electrical connector) the mechanic must discharge static electricity by briefly touching the door striker plate, or similar. — Remove front passenger's seat .
2. With ignition switched off, disconnect battery earth wire 27.
3. Attach front seat to seat repair standVAS 6136.
4. Remove front seat backrest .
5. Disengage fastening strips (1, 2, 3) on back of seat pan (4).

6. ⚠ Make sure the cover does not tear at the opening for the ISOFIX bracket. — Pull cover (1) to front off ISOFIX brackets (2).
7. Remove bolts (2). [Note: For greater clarity, padding is shown without cover in illustration.]
8. Lift ISOFIX retainer (1) off seat pan (3)(arrow). [Note: Make sure electrical connectors are fitted correctly (as far as stop) and engage audibly.]
9. ⚠ Observe safety regulations for pyrotechnic components .Before handling pyrotechnic components (e.g. plugging in the electrical connector) the mechanic must discharge static electricity by briefly touching the door striker plate, or similar. — Switch on ignition.
10. ⚠ The battery must be connected with the ignition switched on. If pyrotechnic components (e.g. airbag or belt tensioner) are inexpertly repaired, this may result in unwanted triggering after connecting the battery. There must not be anyone in the vehicle while you are connecting the battery. — With ignition switched on, connect battery earth wire 27. [Note: If airbag warning lamp K75 indicates a fault following installation, you must interrogate, erase and then re-interrogate the fault memory .]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing door cover (front) – Audi Q7
• Removing and installing heat shield (rear) for longitudinal member
• Removing and installing heat shield for tunnel (gearbox)
• Removing and installing air conditioner compressor drive shaft
• Removing and installing driver side windscreen wiper motor V216 with wiper motor control unit J400