Removing and installing internet access control unit J666 — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

Don't miss

• When fitting bracket (1), make sure that domes (arrows) are located correctly in bracket (1).

📋 Procedure

1. Switch off ignition and all electrical equipment and remove ignition key.
2. Remove glove box General body repairs, interior68Shelves / trim panels; Removing and installing glove box.
3. Release and unplug connector at internet access control unit J666.
4. Remove bolts (2) at bracket (1).
5. Detach bracket (1) from glove box (4) together with internet access control unit J666(3).

6. Pull internet access control unit J666 off bracket.
7. Installation is carried out in reverse sequence; note the following:
8. Slide internet access control unit J666(1) into bracket (2) until it engages audibly (arrows).
9. When fitting bracket (1), make sure that domes (arrows) are located correctly in bracket (1).
10. Remove protective foil from internal battery.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing four-way lumbar support (version 1)
• Removing and installing rear seat bench – Audi A6/A7 C7
• Removing and installing cover and padding for split backrest (rear): 1/3 section of backrest (left-side)
• Removing and installing frame for sunroof operation – Audi
• Installing side window – Audi A3