Removing and installing inner tail light cluster (LED) - Saloon vehicles up to model year 2012 — AUDI

🧭 Before you start

Fits: Audi A4 B8 (8K, 2007–2015)

Don't miss

• Ensure that seal between body and tail light housing seals completely.
• As the nuts are tightened the retainer brackets become wedged in the rear lid (arrows).

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Turn light switch to position "“0”".
3. Lever off cover (1) with removal wedge3409(arrow).
4. Unplug electrical connector (5).
5. Remove nut (2) and detach retainer bracket (large) (1).

6. Remove nut (4) and detach retainer bracket (small) (3).
7. Detach inner tail light from the outside. [Note: Ensure that seal between body and tail light housing seals completely.]
8. Position inner tail light cluster at outer edge of rear lid.
9. Fit retainer bracket (small) (3) onto stud on inner tail light cluster and loosely fit nut (4).
10. Fit retainer bracket (large) (1) onto stud on inner tail light cluster and tighten nuts (2) and (4). [Note: As the nuts are tightened the retainer brackets become wedged in the rear lid (arrows).]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing brake disc – Audi A8 D4 · 1 torque figures
• Removing and installing Haldex coupling, Audi A1
• Removing and installing right air duct with control motor for right side window defroster flap V410 · 2 torque figures
• Dismantling and assembling drive shaft, inner constant velocity joint
• Removing and installing solenoid valve block – Audi A6 C6 · 1 torque figures