Removing and installing horn or dual tone horn H1, vehicles up to 2010 — AUDI
Removing and installing horn or dual tone horn H1, vehicles up to 2010 on Audi: 7 steps, 1 torque figure.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Tighten bolt securing bracket to body |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical loads, and pull out ignition key.
- Remove radiator grille General body repairs, exterior66Mouldings and trims; Removing and installing radiator grille
- Remove plastic cover (1).
- Unscrew securing bolts (arrows) and remove cover plate.
- Unscrew securing bolt (arrow) and remove horn or dual tone horn H1 together with bracket.
- Release and disconnect connector (arrow).
- Tighten bolt securing bracket to body to 20 Nm when installing. — 20 Nm (15 lb-ft)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing fuel tank, four-wheel drive, engine codes BJB, BLS, BSU
- Removing and installing fuel gauge senderG, front-wheel drive, engine codes CAYD, CAYE, CFHC, CFHE, CFHF, CLCA, CFJA
- Removing and installing pop-up cylinder
- Removing and installing fuel tank, petrol – Audi 2.0 BSX
- Assembly overview - cylinder block, gearbox end · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.