TorqFix

Removing and installing hinges - Saloon: Audi A4 B8

Step-by-step removing and installing hinges - Saloon for the Audi A4 B8: 17 steps. What to remove, in what order, and what to check after.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

17 steps

🧭 Before you start

Fits: Audi A4 B8 (8K, 2007–2015)

Don't miss

  • On left side of vehicle, spring eye on retaining pin must point downwards, as shown in detail view.
  • On left side, attach spring at location (d) after installing buffer stop for rear lid hinge.
  • Catch must engage audibly on clip.

📋 Procedure

  1. Only loosen rear nut on rear lid and unscrew the two nuts on the side.
  2. Unscrew fastening rings on bottom of luggage compartment side trim.
  3. Press luggage compartment side trim towards centre of vehicle, unscrew bolts beneath rear shelf and take out hinge.
  4. Insert hinge under rear shelf and secure lightly with nuts.
  5. Position rear lid on hinge and secure with nuts.
AUDI? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Engage spring and gas strut.
  2. Carefully close rear lid.
  3. Align rear lid at sides and lengthwise.
  4. With rear lid open, first attach spring to hinge and then to body.
  5. On left side of vehicle, spring eye on retaining pin must point downwards, as shown in detail view.
  6. On right side it should point upwards.
  7. On right side of vehicle, attach spring at point (a).
  8. On left side, attach spring at location (d) after installing buffer stop for rear lid hinge.
  9. Detach cover from spring at side and pull off retaining pin towards rear.
  10. To remove, push catch on clip to side and release.
  11. Clip buffer stop (2) into place under rear shelf (1) in direction of -arrow-.
  12. Catch must engage audibly on clip.

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.