Removing and installing headlights, headlights with H7/H15 bulb, as of model year 2010 — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

Don't miss

• When fitting headlight in bracket, ensure side guide is seated correctly (arrow).

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Detach front bumper cover General body repairs, exterior63Front bumper. [Note: The bumper cover does not have to be removed completely. For the headlight in question, it is sufficient to remove the fastenings at the front and at the sides of the bumper cover. The bumper cover can then be press downwards carefully until the lower bolt securing the headlight can be reached.]
3. Release and disconnect connector (arrow).
4. Remove securing bolts (arrows).
5. Take headlight out forwards.

6. When fitting headlight in bracket, ensure side guide is seated correctly (arrow).
7. Screw in all bolts.
8. Align headlight with wing.
9. Tighten all bolts to specified torques .
10. Check functions of headlight.
11. Checking and, if necessary, adjusting headlight setting .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing chip card reader control unit J676
• Removing and installing voice control system (from week 36/08 onwards)
• Removing and installing DVD player R7 – Audi A8 D3
• Bleeding fuel system after installing high-pressure pump - vehicles with engine codes BMK, BPP, BSG, BNG, ASB
• Removing and installing selector lever handle on vehicles up to 11.2005