Removing and installing headlights, Arteb headlights with H1 bulb — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

Don't miss

• Insert headlight into bracket. When doing this, make sure that the lateral guide (arrow) is correctly seated.

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Unscrew upper securing bolts (arrows) from headlight.
3. Loosen front bumper cover on the respective side and carefully push it until the lower bolts can be reached.
4. Unscrew lower securing bolts (arrows) from headlight.
5. Using a screwdriver, push connector off headlight from below (arrow), while lightly pressing headlight upwards and towards the side.

6. Take headlight housing out forwards.
7. Insert headlight into bracket. When doing this, make sure that the lateral guide (arrow) is correctly seated.
8. Start all securing bolts.
9. Use adjuster screw to align headlight (arrow) in relation to the body.
10. Tighten all securing bolts to torque specified in assembly overview .
11. Check functions of headlight.
12. Checking and, if necessary, adjusting headlight setting .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing air supply unit – Audi A6 C6
• Removing and installing fresh air blower V2 (with J126 control unit) · 1 torque figures
• Detaching refrigerant lines from front expansion valve/re-attaching
• Removing and installing front expansion valve – Audi A4 B9
• Renewing brake caliper (1LA / 1LB) – Audi A4 B9