Removing and installing headlight range control motor, headlights with H7/H15 bulb, vehicles as of model year 2010 — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

Don't miss

• Make sure cover cap is correctly seated when installing. The ingress of water will lead to permanent damage to the headlight. — Check function of headlight.

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Remove headlight .
3. Carefully cut open area (A) in headlight housing using a suitable tool.
4. Unscrew the two securing bolts (1) and remove headlight range control motor.
5. Insert new headlight range control motor and secure it in place with the two bolts (1).
6. Install cover cap (3) with seal (1) and the two bolts (2).
7. ⚠ Make sure cover cap is correctly seated when installing. The ingress of water will lead to permanent damage to the headlight. — Check function of headlight.
8. Checking and, if necessary, adjusting headlight setting .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling shift mechanism with Tiptronic (assembly overview)
• Removing and installing air conditioner - vehicles up to Model Year 1996
• Testing data exchange between engine control unit / ABS control unit / gearbox control unit
• Checking secondary air pump relay -J299 and actuation
• Testing data exchange between engine control unit, ABS/EDL control unit and gearbox control unit