Removing and installing handbrake cable, Caddy 2011 ▶ — AUDI

🧭 Before you start

Fits: platform code 2C0

Don't miss

• The centre console is not shown to improve clarity.

📋 Procedure

1. Release handbrake.
2. Remove drinks holder General body repairs, interior68Compartments, covers and trims.
3. Unclip cover from centre console (if fitted). [Note: The centre console is not shown to improve clarity.]
4. Release adjustment nut (arrow) until relevant handbrake cable (1) can be detached from compensator (2).
5. Press lever on brake caliper (1) forwards and unhook handbrake cable.

6. Detach handbrake cable by pressing the locking lugs out of the bracket on brake caliper.
7. Remove retaining clip of speed sensor wire.
8. Unhook handbrake cable (3) from bracket (2).
9. Pull handbrake cable out of guide pipe.
10. Push handbrake cable into guide pipe and attach it to bracket.
11. Push handbrake cable into bracket on brake caliper until clip engages.
12. Press lever on brake caliper forwards and attach handbrake cable.
13. Secure speed sensor wire to handbrake cable.
14. Attach handbrake cable (2) to compensator (3).
15. Pretension handbrake cable with adjustment nut (1).
16. Adjust handbrake .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing balancer shaft for exhaust camshaft
• Checking holding pressure, engine codes AXD, AXE, BLJ, BNZ, BPC
• Removing and installing curtain airbag with igniter, front seat area
• Removing and installing seat pan cover and padding, Multivan
• Removing and installing catalytic converter (engine codes BJJ, BJK, BJL, BJM)