Removing and installing gearbox mounting - vehicles with manual gearbox — AUDI

🧭 Before you start

Fits: Audi A1 (8X, 2010–2018)

Don't miss

• Disregard (item 4).
• Renew the bolts tightened with specified tightening angle.

🔧 Engine codes this applies to

📋 Procedure

1. Remove air cleaner housing .
2. Version for countries with cold climates: Unplug electrical connector (2).
3. Press release tabs and disconnect crankcase breather hose (1).
4. Disconnect vacuum hose (arrow).
5. Remove bolt (3), swivel air pipe with connection to rear and detach from turbocharger. [Note: Disregard (item 4).]

6. Remove vacuum hose (arrow 1) for brake servo with grommet (arrow 2).
7. Unscrew nuts (1) and bolt (3), and push electronics box (2) to the side.
8. Position support bracket10 - 222 A on bolted flanges of wing panels as shown in illustration.
9. Attach hook of spindle10 - 222 A /11 to engine lifting eye (rear left).
10. Remove bolts (arrows) securing gearbox mounting (1).
11. Remove bolts (arrows A, B, C) and detach gearbox mounting. [Note: Renew the bolts tightened with specified tightening angle.]
12. Install air cleaner housing .

Other AUDI procedures

• Renewing vacuum unit for turbocharger · 3 torque figures
• Renewing vacuum unit for turbocharger – Audi TT Mk2 · 4 torque figures
• Checking fuel pressure sender – VW 1.4 · 6 torque figures
• Removing and installing throttle valve module J338 · 6 torque figures
• Adjusting vacuum unit for turbocharger – VW Jetta VI · 3 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures