5-speed manual gearbox 01A, four-wheel drive — Removing and installing gearbox mounting — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)

📋 Procedure

1. If fitted, loosen quick-release fasteners (3) and remove rear noise insulation (B).
2. Disconnect exhaust system at clamps (arrows).
3. Use engine and gearbox jackV.A.G 1383 A to lift gearbox up slightly. Insert a wooden block (1) between gearbox and gearbox jack.
4. First remove bolts (3) and then bolts (2) at tunnel cross member.
5. Lower gearbox slightly.

6. Unscrew the two nuts (1) and push tunnel cross member backwards slightly.
7. Unscrew gearbox mounting (arrows).
8. Secure gearbox mounting to gearbox (arrows).
9. Bolt tunnel cross member onto gearbox mounting (1).
10. Lift gearbox far enough to be able to fit bolts (2).
11. Bolt tunnel cross member to body. First install bolts (2) and then bolts (3).
12. Align exhaust system so it is free of stress 26.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Dismantling and assembling clutch "„A"" – Audi A8 D3 / A6 C6
• Dismantling and assembling clutch "„B"" – Audi A8 D3 / A6 C6
• Renewing grooved ball bearing for input shaft with gearbox removed (gearbox remains assembled) · 2 torque figures
• Dismantling and assembling clutch "„E“"
• Removing and installing dryer cartridge – Audi Q7 · 2 torque figures