Removing and installing gearbox mounting and tunnel cross member — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B6/B7 (8E)

Don't miss

• The gearbox support T10337 can also be used in place of the block of wood (1).

📋 Procedure

1. If fitted, open quick-release fasteners (2 ... 3) and detach rear noise insulation (B).
2. Disconnect exhaust system at clamp (arrows).
3. Use engine and gearbox jackV.A.G 1383 A to lift gearbox up slightly. Insert a wooden block (1) between gearbox and gearbox jack. [Note: The gearbox support T10337 can also be used in place of the block of wood (1).]
4. First remove bolts (3) and then bolts (2) at tunnel cross member.
5. Lower gearbox slightly.

6. Unscrew the two nuts (1) and push tunnel cross member backwards slightly.
7. Remove bolts (2) for gearbox mounting (1) and detach gearbox mounting.
8. Secure gearbox mounting (1) with bolts (2). Tightening torque
9. Bolt tunnel cross member onto gearbox mounting (1). Tightening torque
10. Lift gearbox until bolts (2) can be fitted.
11. Screw in bolts (2) and bolts (3) hand-tight.
12. Tighten bolts (2). Tightening torque
13. Tighten bolts (3). Tightening torque
14. Install exhaust system so it is free of stress Engine, mechanics26.
15. Install noise insulation below gearbox.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing headlight fan V407/V408 - vehicles up to model year 2014
• Removing and installing rear exterior door handle switches
• Removing and installing front parking aid warning buzzer H22
• Removing and installing humidity sender G355 - vehicles with main beam assist
• Removing and installing alarm horn H12 – Audi A8 D4