Removing and installing gas gauge sender G707 — AUDI
Removing and installing gas gauge sender G707 on Audi: 8 steps, 1 torque figure, engines BCA, BGU, BSE, BSF.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 7 Nm (5.2 lb-ft) | Tighten bolts (arrows) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Removing fuel tank (Autogas) .
- Draining fuel tank (Autogas)
- Removing the upper cover .
- Removing the lower cover .
- Unscrew bolts (arrow) and eject line from the connector.
- Install in reverse order. In the process, note the following:
- "“Top”" must be at top.
- Tighten bolts (arrows) to 7 Nm. — 7 Nm (5.2 lb-ft)
Other AUDI procedures
- Removing and installing engine control unit J623 (Golf model year 2004 ► 2008) · 1 torque figures
- Checking fuel delivery rate, engine codes BSE, BSF
- Removing and installing natural gas tank 5, Caddy Maxi · 1 torque figures
- Removing and installing radiator fan V7 and radiator fan 2V177
- Checking fuel delivery rate, engine code BGU
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.