Removing and installing fuse holder FSF: Audi Q7
Step-by-step removing and installing fuse holder FSF for the Audi Q7: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi Q7 (4M, 2015–)
Don't miss
- Exact assignment of contacts can be found in applicable current flow diagram .
📋 Procedure
- Remove luggage compartment side trim (left-side) General body repairs, interior70Luggage compartment trim panels; Removing and installing luggage compartment side trim.
- Unplug electrical connectors (2, 3).
- Move connector (1) clear.
- Disengage catches (arrow).
- Lift fuse holder F (item 4) and pull off towards right.
- Release retaining clip in direction of (arrow) and press fuse carrier (2) out of fuse holder F (item 1) towards rear.
- Release retaining clip and press off additional fuse holder (2).
- Release retaining clips (arrows) to pull relay (1) and control units out of relay carriers.
- Release retaining clips (arrows) and pull relay carrier (2) out of fuse holder F (item 1) towards rear.
- Remove fuse holder F. [Note: Exact assignment of contacts can be found in applicable current flow diagram .]
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Installing gearbox, vehicles with 2.0 ltr. TFSI engine · 3 torque figures
- Removing and installing digital TV tuner R171 – Audi A6 C6 · 4 torque figures
- Removing gearbox on vehicles with 6-cylinder petrol engine · 2 torque figures
- Disconnecting and reconnecting battery · 5 torque figures
- Removing and installing mounting bushes on bracket for power steering pump and oil cooler · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.